1）Technical Data A. Counting Speed：> 1000pcs/min, B. Hopper & Stacker Capacity： >130pcs C. Banknote Size：Max. 90ｘ 175mm, Min. 50ｘ 100mm D. Counting Display Range：1-999pcs/1-9999pcs, E. Preset Display Range：1-999pcs/1-9999pcs F. Power Supply：220V (1±10%), 60Hz ,110V (1±10%), 60Hz G. Max. Working Current：0.5A, H. Ambient Temperature：0 ~ +40℃ I. Relative Humidity：40% ~ 90%, J. Noise：< 80dB， K. Power Consumption：<80W L:Size of package:405mm*295mm*255mm M. Weight： 8.0kg 2）How to operate APlug the cord into the right power supply socket. If your counter has the outer display, please plug to connect well. BAfter switching on (better in performance to keep it set-up running for one minute), your counter will start self-diagnosis, and then enter “MG 1/UV” working mode when no trouble is detected. Now only feed banknote to keep it working. When some code appears in display, please refer to the chapter of “Common Trouble & Solution” to solve the problem before normal working. 3）Caution & Maintenance 3.1. Rated power supply: AC220V（±10%）60HZ ; and optional for AC110V（±10%） 50Hz. Be sure to cut off power supply and unplug the cord before disassembling or stopping for a time. 3.2. Keep far away from some electric appliances (e.g. cell phone or welder) that can cause interference on power supply while using. Avoid direct strong light or magnetic field; otherwise, the counter may not work desirably. 3.3. Protect feeding wheel, driven wheel, drag rubber against touching with grease; otherwise, the feeding wheel may be sliding to cause counting error.3.4. In case of sudden failure of power supply, please switch on again after at least 5 seconds; otherwise, the counter may not work normally.3.5. Completely clean counting tube and sensors once every week. Only take part the top shield, use a brush to clear away the dust. (Be sure to cut off the power supply before cleaning) 3.6. Keep the counter well grounded (earth wire), as the counter may produce static charge in use. Don’t store the counter in a wet place, which may cause electric shock.3.7. Be sure to cut off the power supply while the counter is not in use for a long time or without operator’s care. 3.8. Please cut off the power supply and contact maintenance worker for repair services in case that the below case happens:A. Heavily broken due to falling B. Not work even by following the operation instructionsC. Function abnormal，D. Liquid splashed onto the counter